Curt T-Connector Vehicle Wiring Harness Installation - 2019 Subaru Crosstrek Video

We have a hitch for that vehicle. For the 2005 Chrysler Town and Country with the stow and go seats, I would recommend the Draw-Tite Class III Hitch, part #75305. We have a video showing the installation of this hitch, I will provide a link to the…

Many of the ball mounts we offer that we offer that fit 2 inch receivers like part #2753 which has a 2-3/4 inch rise or 4 inch drop, that are designed to be able to use in a rise or drop position by simply turning it upside down, without losing any…

You've got good instincts. I recommend going with a ball mount that has a 2 inch rise for the exact reason you mentioned, the truck will settle a bit with the tongue weight and any cargo weight. The ball mount we offer with a 2 inch rise is the…

The trailer hitch I recommend for your 2018 Subaru Impreza Wagon is the Draw Tite part #76209 because it has a 2 inch opening which most bike racks and accessories are made for, and because it has plenty of tongue weight capacity for your bike racks…

I've provided a photo of the etrailer #e98912 Class III hitch installed on a 2019 Subaru Crosstrek. There were no appreciable changes to the rear of the Crosstrek for the 2020 model year, so the hitch would appear the same as shown on the 2019.…

When replacing a trailer wiring connector that carries a 12 volt accessory circuit like a 7-way like the part #PK12703 it would be wise to disconnect the battery as that circuit is hot all the time and it could cause a short. But if you were…

If you look at the installation instructions, I have linked for trailer wiring harness #C55369, disconnecting the vehicle battery is not required. I have also included a link to a video showing a typical installation for you.

I would be happy to help you clear up the confusion! To control a trailer's brakes with your 2019 Subaru Crosstrek you are going to need to add a 7-way connector and a brake controller. If you do not already have a 4-way harness like item #C56040…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The install of the Curt hitch part #C13382 on a 2019 Subaru Crosstrek does not require drilling but it does required you to enlarge the access hole that you sent us a picture of. I attached a picture of the step in the install instructions that…

The Thule Rapid Crossroad Roof Mounted Railing Foot Pack you have looks like the cap is already open enough to use a separate allen wrench/hex tool to tighten your bars if you want to leave them in place. If not, I recommend drilling out your locks…

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…