Install: 7-Way Pre-Wired Car Connector, 7' Lead on a 1993 Dodge Ram Pickup Video

I would be happy to and thanks for the pictures! The B&W Heavy-Duty Trailer Hitch item #BWHDRH25122 measures 5.4" from the top of the frame brackets to the top of the receiver and 19-1/2" to the back of the receiver from the last bolt.…

The Curt #13028 is designed to fit the 1981 - 1987 Chevrolet C/K Series Pickup 6 Foot Bed with Standard or Step Bumper. Assuming everything with the frame is the same as it was from the factory this hitch will line up and fit your 1986 Chevy. It…

I went out to the warehouse and pulled Curt Class V Trailer Hitch #C15300 and took some measurements for you. From the front bolt hole to the rivet (center to center) is 1-5/16 inches. From the rivet to the rear bolt hole is 7-7/8 inches and the…

For your 1984 Dodge Ram 250 custom the correct B and W trailer hitch comes down to the style of bumper you have. The part #BWHDRH25122 fits a standard size bumper which looks like an average truck bumper and drops down 2-3/4 inches from truck frame…

The distance between the mounting bolt holes on the B&W Heavy-Duty Trailer Hitch Receiver #BWHDRH25122 will be 5-3/4" for the closer set and then 11-3/8" for the set that's further apart (see attached photo). All of the hitches we…

If your 1989 Ford F-150 has a standard or step bumper AND the frame measures 37-1/4 inches from left to right (outside to outside) then you can use trailer hitch #75038. If your truck has the deep drop bumper then you will need #41504 with adapter…

When measuring the frame width on a vehicle, you will need to measure from the outside of one frame rail to the outside of the other frame rail. It sounds like you have the 37-1/4 inch frame on your 1983 Ford F-100. The Curt Class IV 2 Inch Hitch,…

I can totally see why that seems like it would help but unless you could ensure that the seal was watertight you'd end up allowing moisture to get into the hitch tube but not able to easily evaporate which would then make potential corrosion even…

It looks like you're asking about the B&W Heavy-Duty Trailer Hitch Receiver, part #BWHDRH25122, for your 1996 Ford F-150. You didn't say exactly which dimensions you're looking for but I went out to the warehouse and measured the…

The distance from the front hole to the middle on the #14001 is 5.2". From the middle to the rear hole is 4.04" and from the front hole to the rear hole is 9.2". The distance across for each set of mounting holes is 36".

The Curt Trailer Hitch Receiver part #14001 which is a fit for a 1993 Dodge Ram is designed for models with the factory step bumper. That said, it should work just fine with most roll pan bumpers it would just sit down a little further than normal…

From side to side, the mounting holes measure 31-1/4 inches apart, center to center. All three sets of holes are the same distance apart. From rear to front, beginning at the rear of the vehicle the distance from the first set of holes to the second…