bing tracking image

Fifth Wheel Wiring Harness Installation - 2013 Ford F-350

content loading

Customers compare 54701-003 to these similar products




Products Featured in this Video



How to Install a Fifth Wheel Wiring Harness on a 2013 Ford F-350


Today on our 2013 Ford F350, we'll be installing the Bargman Fifth Wheel Gooseneck 90 degree Wiring Harness with 7 pull plug, part number 54701-003. To begin our install, we'll first locate a suitable mounting point.Then we'll go ahead and make a pilot hole. The pilot hole is for our larger hole saw bit, which we'll then go ahead and cut out, so that we can feed our wires down and underneath the vehicle. Now with the cut out from our hole saw made, we'll go ahead and take the key connector and feed it through the hole in the bed, and ultimately, down and underneath the vehicle. Next we'll take the new 7 pull plug, and secure it here to the side of the bed, using theself tapping screws provided with our install kit.Our next step will be removing the older manufacturer's wiring from the manufacturers 7 pull plug, mounted below the bumper at the hitch. To gain access to it, we'll first go ahead and remove the push pin connector that secures the wiring to the top of the hitch.

Then we'll press on the two metal locking tabs that secure the 7 pull plug to the 7 pull bracket. Now, we'll go ahead and pull the wiring and plug through the bracket, togain access to it. Here we can press on the locking tab of the connector and remove the 7 pull connector from the 7 pull wiring. We'll go ahead and feed the wiring back over the hitch. Next,we'll go ahead and take the new 7 pull wiring , route it over the frame, and down back behind the bumper.

We'll take one end that matches our manufacturer's wiring and plug directly into it and then give it a quick tug tomake sure it locks in place. Take the other end, andfeed it between the hitch and the bumper back to the manufacturer's 7 pull bracket. Once we feed it through the bracket, we can go ahead and (reinsecure00:00:01:42)the manufacturer's 7 pull to the new t-connector wiring harness. Once secure, we'll go ahead and reinstall the manufacturer's 7 pull in the 7 pull bracket. Next,we'll go ahead and take some zip ties and secure the wiring up underneath the bed.

Once we secure our wiring, we'll go ahead and cut off the excess from the zip ties and clean up our install look and we're ready to hit the road. That does it for the install of the Bargman Fifth Wheel Gooseneck 90 degree Wiring Harness,part number 54701-003 on our 2013 Ford F350. .


Info for this part was:

Employee Joe V
Test Fit:
Joe V
Employee Andrew S
Test Fit:
Andrew S
Employee Brent H
Test Fit:
Brent H
Employee Shane H
Test Fit:
Shane H
Employee Robert C
Test Fit:
Robert C
Employee David F
Test Fit:
David F
Employee Zack K
Video Edited:
Zack K
Employee Joshua S
Video Edited:
Joshua S
Employee Jacob T
Video Edited:
Jacob T
Employee Kathleen M
Video Edited:
Kathleen M
Employee Dustin K
Video Edited:
Dustin K
Employee Sue W
Video Edited:
Sue W
Employee Chris R
Video Edited:
Chris R
Employee Andrew K
Video by:
Andrew K
Employee Alan C
Video by:
Alan C
Employee Michael B
Video by:
Michael B
Employee Cole B
Installed by:
Cole B

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.