Flex-a-lite Transmission Coolers Manufacturer Demo Video

When comparing the Flex-a-lite Transmission Cooler #FLX400117 to the similar Derale Series 8000 Transmission Cooler #D13502, there are very few differences between them. Both have an aluminum construction, include all hardware needed, and are…

I'd be more than happy to help out! The Flex-a-lite Transmission Cooler #FLX400117 has mounting holes that measure 6-1/4" across and then 2-3/4", 2-7/8", and 2-3/4" side to side as you can see in the attached photo. The…

Yes, in fact the transmission coolers we sell are designed to be supplemental coolers, not direct factory replacements. We typically suggest installing our cooler downstream from the factory cooler. I attached a link to our transmission cooler…

To convert your 4-way to a 7-way so that you can install a brake controller in your 2013 Toyota FJ Cruiser will require the kit part #ETBC7. For a brake controller I would recommend the Prodigy P3 Brake Controller part #90195. This is our best…

The Flex-a-lite Transmission Cooler #FLX400117 does come with everything needed to install. No other components would be needed.

You will most likely need to add a little transmission fluid after the install of the Flex a Lite transmission cooler part #FLX400117 since most likely you will leak out a little during the install and the cooler will add some volume as well.…

If you were hoping for easy installs on your 2021 Honda Pilot, you are definitely in luck! To start with, the Tekonsha T-One Vehicle Wiring Harness #118291 is a plug and play option that will be a very easy way to get a 7 Way plug, which is needed…

The Draw-Tite Class III trailer hitch part #76290 for the 2020 Honda Passport does not require bumper or fascia modification. The installation is simply lining the bracket holes up with the frame holes and using the included hardware to tighten it…

As far as transmission coolers go, you cannot cool transmission fluid too much, so installing the largest cooler that the space on your 2011 Dodge Nitro will allow is perfectly fine and will benefit your transmission the most. Ideally you want the…

I would recommend going by your owners manual. If you have the ATF cooler installed, you can haul the 4,000lb trailer. Make sure that your hitch can withstand that load if you do not have the OEM hitch that came with the truck.

We haven't yet had the chance to install either the Draw-Tite #76290 or the Curt #C13421 on a 2019 Honda Passport, so those measurements aren't available to me, unfortunately. That being said, based on the photos I attached comparing the two,…

Neither the Curt #C13421 or Draw-Tite #76290 trailer hitch receivers you were looking at for your 2021 Honda Passport will mount through the bumper like the factory hitch would. These receivers mount just under the bumper and leave just the receiver…