MaxxAir MaxxFan Plus Manufacturer Review

content loading

Customers compare V3094-601-00C to these similar products




Products Featured in this Video











Manufacturer Review of the MaxxAir MaxxFan Plus


Hi, I'm Mark Polk with RV Education 101. Today, we're going to install the most popular product ever designed to help with RV ventilation, the MaxxAir standard vent cover. The MaxxAir Vent Cover lets fresh air in your RV anytime, rain or shine, helping to prevent heat buildup and promote cross ventilation in your RV. It is designed to mount over all existing 14 x 14 inch roof bins and with the redesigned zero leak hardware kit it works on the new E-Z Lift Vent from Ventline too. Enough talking, let me show you how easy the MaxxAir Vent Cover is to easy stall. The E-Z Lift Vent by Ventline makes it easy to install MaxxAir Vent Cover. It has pre-drilled mounting locations for the redesigned zero leak brackets.

The first step is to place a carriage bolt, provided, upward thought the square slot in the one of the redesigned zero leak mounting brackets. Fasten the bracket to a pre-drilled location on the E-Z Lift Vent. Secure using a small screw, washer, lock washer, and hex nut provided. The hex nut should be placed on the inside of the mounting location. When all of the brackets are installed place the MaxxAir Vent Cover on the four upward pointing carriage bolts with the louver area facing the rear of the RV. Secure it using the star washers and hex nuts provided.

It may be necessary to push the head of the carriage bolt up into the bracket slot to prevent it from turning while you tighten the nuts. A slight air gap between the MaxxAir base and the roof of the RV is normal and helps condensation to escape. Do not apply caulking to this area. That's all there is to installing your standard MaxxAir Vent Cover. This super tough one piece design has withstood the test of time and is the only vent cover tough enough to come with a six year limited warranty.


Questions and Comments about this Video

Sue S.

How is it mounted on other roof vents?

Etrailer Expert
Reply from Heather A.

As long as the vent is a standard 14-1/4" x 14-1/4" the installation will be the same.

Info for these parts were:

Employee Zack K
Video Edited:
Zack K
Employee Jacob T
Video Edited:
Jacob T
Employee Chris R
Video Edited:
Chris R
Employee Jeff D
Installed by:
Jeff D
Employee Joshua S
Video by:
Joshua S
Employee Zach D
Video by:
Zach D
Employee Jonathan Y
Video by:
Jonathan Y
Employee Shane H
Test Fit:
Shane H
Employee Ryan G
Test Fit:
Ryan G

At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.