The Low-Down on the Alpha Systems 1021 Self-Leveling Sealant for RVs Video

Hey Eric, Since both of your units run off of one thermostat the Advent, as well as the other options we currently offer would not be a compatible match. You would have to completely replace the Dometic system with something like the Furrion Chill…

Hi Rusty; the Dexter #84546UC3-EZ and etrailer #AKHD-5475-35-K will both fit a 3,500 lb axle but they have different bolt patterns. You already ordered the Dexter in the past so I'm assuming your wheels are 5 on 4-1/2. For the same bolt…

Hi James; we have one wiper seal that matches the 2-3/4" measurement you have. The Rubber Wiper Seal for RV Slide Out #CS64VR measures 15' long x 2-3/4" wide x 1/4" tall and sticks on for installation. We also have…

We do have the panels separately. What you're looking for is the Go Power Overlander Expansion Kit - 200 Watt Solar Panel #34282182.

There are going to be two options for best caulk or sealant for your RV and it is going to depend on where your are using it. If you are on your roof you will want a self leveling sealant like the Alpha Systems 1021 Self-Leveling Sealant for RVs -…

For an RV with a currently installed Dometic Duo-Therm 59516.531 AC unit, I recommend the Advent Air for Dometic Setups, #ACDOM150. This is a 15,000 Btu replacement option that plugs directly into your current Dometic setup and works seamlessly with…

To wire two 6-volt batteries in series to produce 12-volts, you would connect the load to the positive terminal of battery #1. Connect the negative terminal of battery #1 to the positive terminal of battery #2. Ground the negative terminal of battery…

The JR Products Deluxe Vent Installation Kit part #3724182 includes butyl tape that is 1" wide by 8' long according to JR Products.

You could remove the roof to fix the staples but that would require a ton of work and can be costly, which is why Alpha said it would be overkill. You could just hammer the staples back down and just use some self leveling sealant like the Alpha…

All trailer roof vents nowadays fit what is referred to as a standard roof vent opening, which is described as "roughly" 14-1/4" x 14-1/4" so the Ventline Ventadome Trailer Roof Vent #V2110SP-24 might be able to squeeze into a…

It sounds like you have the 3/4 inch trim on your RV, which we do carry. For a 25-ft roll you can use part #CAM25173, and for a 100-ft roll you can order part #CAM25272.

Since you're adding more you'll want to wait for it fully cure and then wipe it down to ensure the surface is clean for the new sealant #AL98KV you'll be laying down to properly bond to the surface.