Review of the etrailer D-Ring Tie Down Anchor Video

For the etrailer D-Ring Tie Down Anchor #RRING-Q6000 you will need to use the Backing Plate #BP05. This will increase surface area for the bolts used to attach the anchor to your floor giving it additional support. I included a video of the…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

You can use the Demco Spare Tire Carrier #DM15851-52 on the wood deck of your tilt trailer. That would really be the best option as you can bolt it right onto the deck. The #DM15851-52 is silver but I also wanted to mention it is available in black…

The Demco #DM15851-76 has 1/2" x 1-1/4" grade 5 bolt with fine threads (.50NF) so you'll want to use 1/2" nuts with a fine thread to secure your tires. There's also a silver version of the carrier using #DM15851-52

I spoke to my contact at Bulldog and they cannot recommend substituting the grade 8 bolts that came with the coupler for a set of hitch pins. This would void the warranty of the coupler and more than likely a few SAE requirements. If you choose to do…

With plywood walls that are as thin as yours, it's possible that they may not support what you are looking to do. The only way you will be able to utilize the Erickson Horizontal E-Track #EM59150 (2 feet) or #E19148 (5 feet) is by installing it…

The Advent Air RV Air Conditioner with Ceiling Vent and Start Capacitor part #ADV94FR requires 3,000 watts for starting and 1,000 watts while running so to power it with a 2,200 watt generator you would also need the SoftStart #SSR54FR.

I do not recommend using the soft start from a Coleman air conditioner on your Dometic Brisk Air II. You want to use a product which has be test to function properly on your AC like the SoftStartRV Soft Start #SSR54FR or a Dometic Soft Start. I have…

It sounds like you will be running screws through both wood and metal to install the etrailer Horizontal E-Track - Galvanized Steel - 2,000 lbs - 94" Long - Qty 4 #e62VR. I would look for some wood-to-metal screws at the local hardware store to…

The Recessed Trailer D-Ring Tie Down with Backing Plate and Hardware, part #RR5K includes one D-ring, one backing plate, and the hardware needed to install the kit. I have attached a photo that shows what is included in the #RR5K kit.

The Brophy D-Ring #RR5K is rated for 5,000 pounds but it depends on what it is mounted to. If the trailer has a steel floor or 2x4 wood floor then it would not be a problem. If it is aluminum you would want to bolt it to a structural crossmember and…

The Atwood #AT15028-22 Air Command Rooftop Air Conditioner w/ Heat Pump requires a dedicated 20 amp circuit. For a 20 amp circuit, the smallest acceptable wire gauge would be 12 gauge. Given the size of the space, this particular unit would work…