Draw-Tite Drawbar for 1-1/4" Hitches Review Video

Both the Curt #C92UR receiver you found and the Draw-Tite #24954 are going to require slight modification to the steel bumper and plastic fascia to fit your 2022 Honda Civic Hatchback. I have linked an installation video near the bottom of the page…

You mentioned a 1 inch shank size for a ball mount, and the industry standard sizes are 1-1/4 inch, 2 inch, or 2-1/2 inch. The 1-1/4 inch ball mounts come in a variety of rise and drop options to allow you to safely tow a trailer level. I've…

A weight distribution system is a device that is installed on a trailer and uses leverage to transfer the weight of the load across the entire towing setup. It's in addition to a trailer hitch and is optional for towing, although sometimes highly…

The stop inside the hitch is not to force customers to purchase certain brand products, but to ensure that a Class II draw bar is not inserted into a Class I hitch. The Draw-Tite hitch you have, part #24812, is a Class I hitch so if the welded stop…

You are probably OK but if you are anything like I am it would be too close for comfort. I wouldn't want to take a chance at potentially causing any damage to my fascia. I recommend the Curt Class II Drawbar - 5" Rise - 11-5/8" Long -…

For a 1-7/8 inch hitch ball to use with the #C45015 or the #C45014 you would want the part #A-80. For a 2 inch hitch ball you would want the part #A-82. Both of these have a 3/4 inch diameter shank that is 2-1/8 inch long.

The two Curt ball mounts you mentioned of part #C45014 and #C45015 are both options that would give you additional rise with the #C45015 being a few inches longer as well than compared to the #C45520 that you have now. Now these options only can be…

It sounds like you may already have a 4 way connector on your vehicle, which is half of the battle. In order to operate the Curt Echo Mobile Wireless Brake Controller #C51180 you will need an almost fully functional 7 way connector; using something…

There is an easy way to make sure you clear the bumper on your 2004 Chrysler Town and Country. You will need a tape measure and a straight edge like a yardstick or a dowel. Hold the straight edge vertically against the rear bumper, making sure it…

The Curt Trailer Hitch Receiver #C98DR for your 2023 Hyundai Ioniq 5 will not reduce your ground clearance since it sits higher than the axle components on your Hyundai. It will affect your departure angle due to hanging below the rear bumper. This…

My recommendation is to have a custom adapter made for the height and length that you need on your 2010 Chevrolet Malibu with the Draw-Tite Trailer Hitch Receiver #36479. The center of the hitch pin is about 8-1/2" from your rear bumper. Any…

I just spoke with my rep at Draw-Tite the bottom of the 1 1/4" receiver for the Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4" item #DT74MR sits 5 1/2" off of the ground. I have attached a picture of the…