Fulton F2 Retractable, Ratchet Transom Tie-Downs Review Video

None of the hitches we offer would have enough weight capacity for a tongue weight of 450 lbs. Highest we have is the etrailer part #e78KR which has tongue weight capacity of 350 lbs. Even still you'd be limited by the capacity of the vehicle…

As far as the tire size discrepancy goes, I believe you have 12 inch diameter wheels, if you indeed have 4.80-12 tires. You can't fit a 12 inch tire on a 13 inch wheel, but if you measured the wheel from the wrong spot, you can easily come up…

I would start by checking to make sure that you're getting power on the 12v auxiliary power circuit on your 2003 Chevy Silverado's 7 way plug; since the Titan BrakeRite #T4813102 receives its' power from this circuit it's possible…

The actuator by itself is not available as a replacement part for the Titan BrakeRite Plug and Play Electric-Hydraulic Actuator Kit #T4813102, you would need to get the full kit if your actuator died on you.

The Blue Ox SwayPro Weight Distribution Shank for 2-1/2" Hitch #BXW4028 weighs 25-lbs. Your current shank, the Blue Ox TrackPro Weight Distribution Shank for 2" Hitches #BLU28FR weighs 20-lbs so the change between the tow really won't…

No, it does not but there are a couple of options to make them work with a 2-1/2" receiver. The Blue Ox SwayPro Weight Distribution item #BXW1006 and item #BXW1000 are only sold with 2" shanks. The least expensive option is to use the Curt…

Since you already have the Blue Ox SwayPro Weight Distribution w/ Sway Control item #BXW1000 I would not recommend buying a new one to go with your Grand Design Imagine 2970rl. The tongue weight range on that Blue Ox is 750-1,000 lbs so you're…

Yes, you can. To use the Blue Ox SwayPro item #BXW1000 with a 2-1/2" receiver you will need the Blue Ox SwayPro Weight Distribution Shank item #BXW4028.

In terms of capability the Dexter DX7.5L A-60 Brake Actuator w Electric Lockout - Bolt On - Disc - 2" Ball - Zinc - 7.5K #DX89FR is a good replacement option. The problem is the design of your old TDE LP7000 which was installed inside the tongue…

You can convert surge brakes to an electric over hydraulic braking system. To do this, you will need an electric over hydraulic actuator and a brake controller. For an electric over hydraulic actuator, I recommend looking at the Carlisle HydraStar…

I'm guessing it is approximately 3-3/8" across if you measured it. Unfortunately there are no options that will slide in because it won't line up correctly, and everything is designed to fit a 3" tongue so it is too wide to mount an…

First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…