Detailed Breakdown of the Rack'Em Shelf Kit for Enclosed Trailers Video

Since you have wooden floors in your trailer the hardware I would recommend for installing e-track like the part #EM19147 would be the Erickson Hardware kit part #SL49FR which is basically wood screws.

Self tappers like the part #SL99FR would work great as they have drill bits on the end which would make it through the metal of your studs and then attach.

The Trailer King RST are a pretty middle of the road tire, not bad but not a top of the line tire. On the other hand the Kenda Loadstar ST tires are a high quality tire designed and strenuously tested in Ohio to make sure the tires are as reliable,…

The fully retracted distance between the hooks of the CargoBuckle Mini G3 Retractable Ratchet Straps #IMF111640 that you referenced is 17-1/2 inches. I confirmed this with CargoBuckle. I also attached a review video for these straps for you to check…

In regards to the Hopkins Engager Push-To-Test Trailer Breakaway Kit part #20400, there are only two wires with the black being power so it should be run to the positive battery terminal and the blue being brake output so it should be run to the…

On this page (typically below the product links) there is a helpful link section that will have the install instructions fo the Hopkins Breakaway kit part #20400 that you referenced. I also attached an install video that shows the kit installed as…

I am not aware of an e or x-track accessory that is designed specifically for carrying kayaks but we do have options for this assuming the tracks are on the walls. I recommend using a few CargoSmart Large Rotating Flat Hooks part #3481701 to suspend…

In order to install the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #C56434 on your 2021 Toyota RAV4 Hybrid, the first thing you need to do is disconnect the negative terminal from the battery. After this step, you need…

Though I'm not sure what you mean by "premium" I can tell you that Oil Seal #91030 does have the exact same 2.750" inner diameter and 3.779" outer diameter of the TKS seal 568303 that is used on AL-KO axles so it will work as…

To replace your AL-KO 568303 seal you will want the Oil Seal #91030. This seal has the same inner diameter of 2.750 inches and outer diameter of 3.779 inches. It is a confirmed fit for your #99 spindle that uses the AL-KO 568303 seal.

Yes, you can use wood screws to secure the e-tracks to the plywood walls in your trailer. However, as you mentioned the weight capacity would be less than if you were to attach them to metal beams. The tracks themselves can handle up to 2,000 lbs but…

The Erickson Horizontal E-Track, part #E19148 has 1/4 inch diameter mounting holes spaced 2 inches apart. The screws you use should be at least long enough to go 3/4 inch into the wood you are mounting the track to. The more screws you use the more…