Stromberg Carlson Base Pad Extreme for RVs and Trailers Spec Review Video

I recommend the Stromberg Carlson Base Pad Extreme, #SC53VR for a quantity of 4 each. Or, #SC33VR for a quantity of 6. These base pads are 7" Tall with 6,000 lbs. individually. If needed, you can stack 2 pads to get 12-3/8" of height and a…

You would not need to use a Stromberg Carlson Base Pad Extreme for RVs and Trailers #SC33VR on each stabilizer but it is recommended. Speaking from experience, there are a lot of awkward camp sites where one end of your 2021 Keystone Avalanche may be…

Hey Dan, so the etrailer bumper cargo carrier part #e99050 that you referenced is designed to attach to 4 inch or 4-1/2 inch square bumpers. If you have an I-beam crossmember that is 4 inch or 4-1/2 inch square I could see this working potentially…

The easiest way to accomplish this would be to start on one side of the trailer and get the springs in place before bolting the axle to the springs with the u-bolts. Have the axle up on jacks or blocks so its weight is not bearing on the springs.…

The spacing will depend on the axle diameter and on which particular spring hanger kit you use. If you have a 6000 lb 3 inch diameter axle, and you're using the #APT5 hanger kit which includes 7-3/4 inch equalizers and 2-5/8 inch shackle straps…

Between the Curt #C60692 and B&W #BWGNXA2061 that will fit your 2022 GMC Sierra 3500 with the factory pucks/prep package, I do prefer the B&W. Though both the Curt and B&W are rated up to 30,000 pounds and will fit your truck perfectly,…

Hey Tim, thanks for reaching out! The Stromberg Carlson Base Pad Extreme for RVs and Trailers #SC33VR have a 6,000 lb rating for each Base Pad Extreme so you're looking at a total of 36,000 lbs for this kit of 6. Ideally your jacks will have the…

It sounds like the dead battery on your trailer may have caused a high amperage current stall error on your Lippert leveling system like the Ground Control #LC358590. What I first recommend doing is simply trying to clear the error message that keeps…

The MORryde RV Cargo Sliding Tray #MR28FR is a total of 6-5/8" tall and sits approximately 1.57" off of the compartment floor. I have included a dimensional diagram of the MORryde RV Cargo Sliding Tray #MR28FR that you can take a look at.

In most cases, the tailgate on your truck can be left installed and in the down position while coupling to a 5th wheel trailer. Once the trailer is coupled you can then most likely raise the tailgate back up. I say in most cases as there could…

Personally I prefer the SnapPad XTRA Jack Pads #SP54FR4 over the Stromberg Carlson #SC99MR as they have been around much longer and proven themselves to be a quality product. Both these will fit 4 jacks with a 9" round landing pad.

I have a universal fit hitch setup that would have more capacity, but you will need to make sure that the RV has the additional capacity you would require as well. A towing setup is only as strong as it's weakest component. You would want the…