Dodge Brake Controller with Wiring Installation And Review Videos

  

Trailer Brake Controller Installation - 1999 Dodge Ram- Video

Trailer Brake Controller Installation - 1999 Dodge Ram

Today on our 1999 Dodge Ram Pickup, we'll be installing the eTrailer Brake Controller Installation Kit, part number ETBC7, in conjunction with the Tekonsha P3 Brake Controller, part number 90195-3020P. To start our install, we're going to go ahead and assemble the 7-pole and bracket using the hardware provided with our install kit. A quick tech tip: Before you install the bracket onto the vehicle, it may make it easier to go ahead and tape up your wires now. This will help protect the wires over time and provides a clean install look. Now, we've secured the bracket to the 7-pole connector. We'll go ahead and secure the bracket to the bumper. more


Watch Video

1/2/2013 10:52:00 AM



Trailer Brake Controller Installation - 2008 Dodge Ram- Video

Trailer Brake Controller Installation - 2008 Dodge Ram

Today on this 2008 Dodge Ram 3500 were gonna install the Tekonsha P3 Brake Controller with direct wiring harness part number 90195-3020P.Our first step is gonna be locating the manufacturers connector for the brake control. The blue connector just above the power control module is the one we need.Well take our direct wire harness and plug directly into the blue connector.Now were plugged into the manufacturers connection, Im gonna go ahead and set my harness aside and we need to mount our brake controller.Well take our mounting bracket that comes with our install kit and simply mount it here underneath the dash. Behind the plastic cover of the dash is a metal bracket and today Im gonna be using self-threading screws to install my bracket. You could drill a small power hole and use the screws that come in the install kit.Now we can go ahead and install the brake controller on our mount.Now with our brake controller mounted, well take the other end of our wiring harness and plug it right into the back of the brake controller.As you can see, the power lit up our brake controller. Now we just need to do some final touch up.Im gonna take a couple of zip ties and secure my wiring up underneath the dash. Simply take the extra from our wiring harness zip tie it off to the manufacturers wiring. more


Watch Video

12/1/2011 3:07:25 PM



Brake Controller Installation - 2000 Dodge Durango- Video

Brake Controller Installation - 2000 Dodge Durango

Today on this 2000 Dodge Durango, we are going to install part number HM47294-47755 from Hopkins. First off, we will go ahead and show you where the port is for the adapter cord that goes between the vehicle and the brake controller. First off, we need a little bit easier access to the port. So what you can do is actually put your finger behind it and be very careful, but you can push it towards the back of the vehicle and pop it loose from its clip that holds it in place. And then you can plug in the brake controller cord. Plug the cord into it. Then we will take the rest of this and route it up over to the other side. We will route it up over the data port cable and the hood release. And what we are going to do is mount our brake controller to this flat surface right here. It comes with these little set screws right here. Let us go put our bracket up here and just run it straight to the plastic. 0:58 more


Watch Video

9/30/2010 1:39:10 PM



  1