Chevrolet Sonic Custom Fit Vehicle Wiring Installation And Review Videos

     

Trailer Wiring Harness Installation - 2012 Chevrolet Sonic- Video

Trailer Wiring Harness Installation - 2012 Chevrolet Sonic

Speaker 1: Today on our 2012 Chevrolet Sonic, we'll be having a look at and installing the Tekonsha T1 Wiring Harness with 4-pole flat trailer connector, part number 118640. Here's what the wiring looks like installed. As you can see, we have an adequate length wire that gets right next to the receiver on our Sonic. This makes it easy for us to hook up to our trailer when we're ready to tow.This wiring harness gives us the basic lighting functions, which are required by law in order for us to safely and legally tow our trailer. Our white wire provides the necessary ground connection between the Sonic and our trailer. Brown wire provides our taillight and running light signal. more


Watch Video

3/12/2018 2:33:21 PM



Trailer Wiring Harness Installation - 2015 Chevrolet Sonic- Video

Trailer Wiring Harness Installation - 2015 Chevrolet Sonic

Today in the 2015 Chevrolet Sonic, we're going to review and install part number 118640 from tow-ready. This is a T1 vehicle wiring harness with a four pull flat trailer connector. We'll go ahead and show you how to use it. Pretty simple. Open up the panel here, pull it out and just bring it over the threshold right here. This rubber seal is thick enough, when you close it, it won't hurt anything. more


Watch Video

2/17/2016 12:22:14 PM



Trailer Wiring Harness Installation - 2012 Chevrolet Sonic- Video

Trailer Wiring Harness Installation - 2012 Chevrolet Sonic

Today on this 2012 Chevrolet Sonic, were going to install part number, 118555 from Tow Ready. First thing we need to do is go ahead and open up the trunk and remove the threshold panel. To remove our threshold we need to remove the liner at the bottom and then well pull out the four plastic rivets. Then well pull them straight from the bottom, you loosen it up, and then pull from the top. Now go ahead and remove the plastic rivets from our liner going towards the corners, towards the wiring for the taillights. Okay we have our driver side loosened up and well repeat the same process over on the passenger side. more


Watch Video

1/31/2013 8:20:44 AM



  1