Troubleshooting Weak Brakes on a Trailer
Question:
I just purchase a brand new 10 ton econoline trailer With al-ok 10,000 lb axles. Ive adjustedthe wheel bearings and adjusted the brakes after the first 50 miles when I got it home and the brakes are not grabby at all I can get the tires to drag in loose gravel which all the other trailers do, it does slow the truck down but should practically stop the truck Dealership wont do anything and econoline wont get back to me. Any advice. Think the trailer sat for maybe a year before being sold. Hate to pull it all apart but I assume that may be the next step
asked by: Ethan
Expert Reply:
If you adjusted the brakes on your trailer so that they drag ever so slightly then the next step that I recommend looking at is the power setting of your brake controller. If your brake controller power setting is not very high then that would be the reason that your brakes are not a strong as you like.
If you have adjusted the brakes and your brake controller and you are still not achieving the desired result then you can check the wiring from your brake controller to the brakes to ensure that it is working properly.
Using a Circuit Tester # PTW2992 test the pin in the 5 o'clock position on the 7-Way on your tow vehicle (see attached picture). You will want to do this by setting your brake controller to the highest setting and then applying the manual override. If you do not get the proper amount of power then you will want to sever the brake controller wire (that sends the signal to the 7-Way) 6 inches from the brake controller and test it to make sure your brake controller is operating properly. If it is then you will need to check the wiring on your tow vehicle. If not, then your brake controller needs to be replaced. I recommend the Tekonsha Prodigy P3 # 90195.
To test your trailer side you can use an alternate source of 12V power, like the battery from your tow vehicle, and apply power directly to the corresponding pin on your trailer side. With a full 12V of power running to them they should definitely activate. If they don't then you will want to test the brake magnets themselves. I have attached a helpful article on how to do this.
If you have issues on either your tow vehicle or trailer then you will want to check the wiring for any places where it is damaged, bent, corroded, or exposed and replace any sections with 10 Gauge Wire # 10-1-1 and Butt Connectors # DW05745-5.
If you are still experiencing trouble then you will want to take your rig to a shop and have them physically inspect it.
Products Referenced in This Question
Deka Heat Shrink Butt Connector - 12-10 Gauge - Nylon Insulation - Yellow - Qty 5
- Wiring
- Wire Connectors
- Butt Connectors
- 12-10 Gauge
- Deka
more information >
Product Page this Question was Asked From
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Choose the Right Trailer Hitch Class
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Q&A: Replacement for Demco Master Cylinder 05680-C for Drum Brakes
- Q&A: Wiring Configuration for Tekonsha Prodigy P3 Trailer Brake Controller 90195
- Q&A: How Does Brake Controller Install on Freightliner S2RV Chassis
- Q&A: Which Nev-R-Adjust Brake Assemblies for Load Trail 14K Dump Trailer