Wire Recommendation to Complete Brake Controller Wiring on Truck Where it's Not Ran
Question:
After installing a new Tekonsha brake controller via a Reece OEM wiring harness I have no connection when the trailer is connected. After tracing some wires I came to find out that the blue brake controller wire from the factory install 7 pin plug a the hitch terminated and is not connected to anything on the opposite side. I can see from inside the vehicle where the brake controller wire enters the engine bay at the firewall but cannot find it on the other side. How and/or where can I attach the wire coming from the 7 pin to complete the circuit? Thanks
asked by: Davd A
Expert Reply:
I'd just run a length of 10 gauge wire like part # 10-1-1 from the 7-way wiring for the brake output circuit (5:00 pin) to the blue wire of the brake controller wiring to bypass the factory wiring of the truck. It can be difficult tracing factory wiring so running a dedicated wire will make this easier.
Products Referenced in This Question
Product Page this Question was Asked From
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Choose the Right Trailer Hitch Class
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Why Is 5th Wheel Trailer Clunking When Starting/Stopping with B&W Companion and MORryde Pin Box
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Does the Tekonsha P3 Trailer Brake Controller Turn Off or Stay On All the Time
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Q&A: Parts Needed To Install A Brake Controller On A 2023 Freightliner Cascadia
- Q&A: Which Nev-R-Adjust Brake Assemblies for Load Trail 14K Dump Trailer