1995 Ford Explorer Side Window Vents

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Hey Frank, The Malone Fairing for Roof Racks #MAL74SR brackets will be compatible with Ford factory crossbars and has a locking knob to adjust the angle of the fairing to fit different crossbar heights so you…

Hey Chip, so we do have a set of Torklift camper tie downs that fit your 2024 Ford F-350 long bed with side steps and a factory hitch with the part number #TL87CR for the front set and part #TLF3008 for the rear set.

Yes, we do have a roof rack kit that will attach to your 2023 Toyota RAV4's naked roof. This system clamps inside your door jams. You will want the roof rack by Rhino Rack…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

I recommend checking out the Curt Echo In-Line Bluetooth Brake Controller #C79DR for your 2024 Jeep Wrangler Unlimited because it tees in behind your factory 7-Way and then allows you to control it via an app on your phone so you…

I recommend going with the Timbren Suspension Enhancement System #TFRSDJ for your 2024 Ford F-450 Super Duty because it's designed better for pickup truck-type…

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from…

Hey there Tom, good question as you correctly noted a couple Curt hitches for your 2021 Chrysler Pacifica Limited non-hybrid. The appropriate one for you really depends on how you want it to look on your Pacifica. One has a visible crosstube and…

The hardware with our etrailer Receiver #e85AR for your 2009 Jeep Liberty is M12-1.75 thread. We do include this size in our Metric Tap Kit #PT22FR if you do not already have it. A Brush #814092 will also help you clean out the threads with some…

That means the programmer you have was installed on a different vehicle and wasn't returned back to stock before you got it. These can only be programmed to one vehicle at…

Since you said you couldn't find a power level option on the Edge programmer you have on your 2008 Ford F-250 there is a great chance you actually have an Insight Monitor…