2020 Jeep Wrangler Vehicle Cargo Control

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

So you have a ReadyBrute tow bar and the link you sent is for Blue Ox base plate adapters. These will allow you to use the Blue Ox Base Plate Kit #BLU53FR on your 2020 Jeep Gladiator. If you wanted to use the etrailer #e98948 you would have to get…

Hi Jeff; thanks for the question and sturdy is definitely a good word for the etrailer tonneau that fits your 2022 Ram 1500 with a 5-1/2 foot bed, the etrailer Hard Tonneau Cover #e35DR.…

Hey Chip, so we do have a set of Torklift camper tie downs that fit your 2024 Ford F-350 long bed with side steps and a factory hitch with the part number #TL87CR for the front set and part #TLF3008 for the rear set.

The Firestone Ride-Rite Red Label Extreme Duty Air Helper Springs #F95FV will be just fine if you need to lift your 2022 Ford F-250 Super Duty, but it will be good practice to lower the psi rating to 5 prior to lifting the truck. I confirmed this…

The BAKFlip MX4 Tonneau Cover #BAK48330 for the 2022 F-250 short bed has 4 panels. While you are using your Demco Autoslide 5th Wheel Hitch #DM8550024 you will be able to keep one panel laying flat on the bed. There are tow ways you can store the…

The Brophy Basic Turnbuckles w/ Hardware for Camper Tie-Downs item #TDHP are going to be the shortest option we carry. With the hooks on the turnbuckle portion out from the inside of one hook to the inside of the other hook is…

For a hard folding tonneau cover that is rack compatible on your 2023 Ford F-150 I recommend the BAKFlip MX4 Hard Tonneau Cover. You will need one of the following based on your bed length: -BAKFlip MX4 #BAK76FR…

Hello Jim, I just checked with my contact at Thule. The Replacement Non-Locking Ratchet Arm Assembly #753357902 will fit your older Thule 515-5190 bike rack.

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Yes, it is! I checked with BAK Industries and the BAK Revolver X4s Hard Tonneau Cover item #BAK62VR you were looking at is compatible with the BAKBox 2 Collapsible Truck Bed Toolbox item #BAK92120. I can confirm that both of these parts will fit…

Hey Jaime, yes you can replace your 25-1/4 inch 3,500 lb axle leaf springs with a 5k rated axle spring like the part #e44SR. This will increase the suspension's weight capacity and…