Filter Products
Filter by Construction
$25.40 - $50.73
Videos
for Boat Motor Accessories
Help Articles
for Boat Motor Accessories
Expert Answers
for Boat Motor Accessories
We do not have any hub caps that fit trailer wheels. If you were wanting to go with something nicer looking you'd need to replace the wheel with something like the Westlake ST205/75-14 part #WST57FR or any of the other aluminum wheel options…
view full answer...The issue you most likely ran into is that winches draw way more amperage than what the 12 volt accessory wire of your 7-way can provide. You would have needed something like the part #BDW20207 to power your winch. Your going to have to start…
view full answer...The difference between a load range E and load range F tire of the same size, 235/85-16, is the weight capacity and pressure. The Karrier Radial Tire, Load Range E, #AM10295, has a capacity of 3,640 pounds at 95 psi. The Load Range F Tire, #AM10501,…
view full answer...Yes, the Timbken bearings part #TMK73VR and #TMK23VR are made in the USA.
view full answer...The reverse light pin on a traditional 7-way trailer connector, like part #PK11893 or a factory connector if that's what you have on your 2018 Ram, is the center pin. Take a look at the picture I attached that shows all the pin functions. To add…
view full answer...A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…
view full answer...The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…
view full answer...We do have a potential solution for you, but the Replacement Inner Member #DX99FR is not a suitable replacement for the TDE 8000LP. The #DX99FR is made only for Dexter DX7.5L and Legacy UFP actuators. The pins will not line up with a TDE I am sorry…
view full answer...Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…
view full answer...This Submersible LED Trailer Light Kit with 25 foot Wiring Harness, part #TLL9RK, uses all stainless steel mounting hardware. The mounting hardware of this trailer light kit should work well in the saltwater conditions that you use your boat in.
view full answer...Since your boat trailer has a 7-way on it currently and has surge brakes what you would want is the 4-way to 7-way adapter part #37185 Kevin. Your 4-way will plug into this and all of the taillight functions of the 7-way will be active. If you also…
view full answer...The marker lights would tie into the running light circuit, which is carried by the brown wire on the trailer wiring harness. I've linked you to a trailer wiring diagram, and also to our trailer wiring FAQ article.
view full answer...