Is Jensen Subwoofer JMPSW800 Compatible with Jensen Stereo AWM968  

The wiring harness for the Jensen Enclosed Amplified Marine Subwoofer #JMPSW800 has a 3-wire pigtail for you to splice in your power, ground, and remote. You would just need to cut the wire down to necessary length and splice it to the remote wire…

Yes, your Jensen stereo has RCA outputs that you could run to the RCA inputs of the Jensen 8" Amplified Subwoofer with Enclosure #JMPSW800 and it would work well.

The Jensen Enclosed Amplified Marine Subwoofer #JMPSW800 has RCA inputs so you could connect it to a soundbar using RCA cables or an RCA adapter to whatever input the soundbar has. It's designed for marine-use so it should be able to withstand…

You could remove your breakaway switch pin while your trailer is in storage, however, a determined thief will get what they want in the end. If he went through the trouble to break in and attempt steal your trailer, it would not be a problem for him…

Yes, the Optronics Flexible LED Light Strip part #UCL90CB is dimmable, you'd just need to make sure to use a dimmer switch compatible with LEDs like the LED Dimmer Rocker Switch part #37215225.

The LED Light Strip for Thule RV Awnings part #TH301660 is 8mm wide and the LED Light Strip for Thule RV Awnings part #TH307135 is 12mm wide but that is the only difference.

I attached a picture to this page that has a wiring diagram for the Furrion Indoor Enclosed Amplified Subwoofer #FSW8P12CF that you referenced. I attached a review video for this for you to check out as well.

The Jensen Enclosed Amplified Marine Subwoofer #JMPSW800 is designed to have RCA cables which are just signal wires ran to it and not speaker wire that carries an amplified signal, but what you can do is get a speaker wire to RCA adapter and…

Yes, the Curt True Course sway control part #C94VV can be used with the Curt Echo Mobile Brake Controller part #C51180. It would just plug into the Echo and then your trailer would plug into it.

The Curt True Course Advanced Bluetooth Trailer Sway Control #C94VV wins for ease of install and it does a really good job but if you were wanting the best sway control that applies the left and right brake assemblies independently the Tuson…

Assuming your trailer is loaded properly (with cargo weight as far forward as possible), and you are using a weight distribution system with sway control built in like the Fastway E2 I wouldn't say an electric sway control like the part…

The label side of the Tuson Electronic Sway Control System for Electric Trailer Brakes #335TSC-1000 needs to face forward and be in a vertical orientation perfectly centered on the trailer 5-10 feet back from the center of the king pin like what you…