How Thick Is The Shaft Hole In CE Smith Ribbed Wobble Roller CE29536?  

If you have enough of the shaft still intact then you can use the CE Smith Wobble Roller Retainer Ring #CE10981 and a Wobble Roller Washer #CE10983 for the Yates Ribbed Wobble Roller #YR343R-6P for a 3/4" shaft. Otherwise you may need to get a…

The Yates Ribbed Wobble Roller, #YR343R-6P, is 3 inches wide when compared to #YR440R which is 4-1/4 inches wide. If the 3 inch width will still work for your application then you can use it in place of the #YR440R roller.

The Yates Ribbed Wobble Roller part #YR343R-6P that you have actually uses a 3/4 inch shaft or if you had the part #YR343R-5P the shaft diameter would be 5/8 inch. I'd maybe try measuring the diameter again and going with the wobble roller that…

We have a few options for replacement rollers that fit 3/4" roller shafts. The Yates Ribbed Wobble Roller #YR530R-6P is 3" wide, 5" in diameter, and fits 3/4" shafts. The Yates Ribbed Wobble Roller #YR343R-6P is also 3" wide…

I went out to the warehouse and measured Yates wobble roller #YR530R-6P. The width of the center is 1-5/8 inches so it will be too large. Your best option is going to be roller #YR440R which is much narrower but the overall width is 4-1/4 inches. The…

The Yates Wobble Roller #YR440R that you referenced should work well for you since it has the same 3/4 inch shaft as your trailer. Wobble rollers are held on with retainer rings like the CE Smith Wobble Roller Retainer Ring #CE10981. Basically, you…

The hub length of the CE Smith Ribbed Wobble Roller for Boat Trailers part #CE29536 is 3/4" per the manufacturer.

We have the Yates Ribbed Wobble Roller for EZ Loader Boat Trailers #YR500YW-8PEZ which has a 1-1/8" inside length. This is the only wobble roller that says it is less than 1-1/2" inside length.

The center hole of the Yates roller part #YR500YW-6P that you referenced is 7/8 inch in diameter and was designed to fit a 3/4 inch diameter shaft.

The yellow and blue rollers are considered "non-marking" rollers so they are the ones I recommend most. Black ones have a tendency to leave marks on boats so usually don't recommend them. I attached a page that has all of the…

The Yates Wobble Roller #YR440R will leave black marks but you can use the yellow version #YR500YW-6P instead to avoid marking up your boat. I confirmed this with my contact at Yates. This has a slightly larger diameter at 5" as opposed to the…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…