Could Damaged Trailer Brake Magnets Cause Low Brake Output Voltage
Question:
Appalachian 14k gooseneck, approx yr 2002. Have determined that controller is outputting full 12 volts at truck receptacle truck wiring ok, and another trailer I have works fine. Trailer plug and wiring look ok upon close inspection but still getting approx 1 volt at magnets. This is a dual axle trailer, so I severed the brake wires to the rear axle to eliminate them, no change in voltage at magnets on front axle. Drums are pretty grooved from the magnets, wondering if the wear could be causing this. I must still electrically check the wiring between the plug and magnets, however visual inspection found no issues. Thank you!
asked by: Michael W
Expert Reply:
Definitely sounds like a bad trailer magnet due to wear that is causing your issues with low brake voltage. I attached a help article that covers how to troubleshoot them as well.
Most likely you'll need to go with new trailer brake assemblies and you'll be back on the road with working brakes.
To pick out the correct brake assemblies for your trailer you need to know a few things.
You will want to measure the inner diameter of your hub/drums and the depth of the drums to determine what brake assembly dimensions you need. For example the part # 23-27 is a 10 inch by 2-1/4 inch thick brake assembly.
You also want to determine what the bolt pattern is of your assembly mounting flange. The standard size is 4 on 4 inch. You also want to determine the axle capacity of your trailer and go with an assembly that has the same rating, the # 23-27 has a 3,500 lb capacity.
Products Referenced in This Question
Dexter Electric Trailer Brake Assembly - 10" - Right Hand - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- RH
- 3500 lbs
- Brake Assembly
- Manual Adjust
- 10 x 2-1/4 Inch Drum
- Dexter
more information >
Product Page this Question was Asked From
Dexter Electric Trailer Brake Assembly - 10" - Right Hand - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- RH
- 3500 lbs
- Brake Assembly
- Manual Adjust
- 10 x 2-1/4 Inch Drum
- Dexter
more information >
Continue Researching
- Shop: 50mm Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 8K
- Search Results: opti brite
- Shop: Opti-Brite LED Work Light - Flood Beam - 1,492 Lumens - Black Aluminum - Square - Qty 1
- Search Results: 12 volt toggle switch
- Q&A: Troubleshooting Malfunctioning Trailer Brake Magnets
- Search Results: gen~y hitch
- Video: Optronics Lights - Utility/Work Lights - TLL71FB Review
- Shop: Trailer Hitch
- Shop: Low Profile LED Flood Light - Angled Beam - 1,000 Lumens - Surface Mount - Clear Lens
- Article: Trailer Wiring Diagrams
- Q&A: Size of Hose Connection on Seaflo Submersible Utility Pump
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Search Results: safety chains
- Shop: Ultra Bright LED Flood Light - 9,000 Lumens - Black Aluminum - Clear Lens - 12V/24V
- Shop: Trailer Wiring
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Gooseneck Hitch
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Search Results: trailer hitch
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Article: Trailer Tire Sizing
- Search Results: trailer jack
- Shop: Suspension Enhancement
- Shop: Fifth Wheel Hitch
- Search Results: switch
- Article: Most Popular Wheel Bearings
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Shop: Brake Controller
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Shop: RV Exterior Lighting