Trailer Brake Controller Installation - 1997 Ford F-250 Video

You are correct, you should only be getting output when the brake is applied, or the override switch is activated. It sounds like the controller might be bad, but to make sure, you should probably bench test it before tossing it. Use a circuit…

In regards to a 1996 Ford F-250, most model have a factory brake controller plug under the dash but there are some out there which don't, those models usually don't have any other tow package components from the factory. However, the…

Since you are not getting the 12V power when your truck is running, you most likely don't have a fuse issue as you stated their isn't a specified fuse or relay in the owners manual. The issue is that your truck is computerized even at…

When wiring a trailer connector, it is best to wire by function, as wire colors can vary. We have an excellent wiring diagram on our website, I will provide you a link so you can look at it. If you are looking at the inside of the trailer connector…

This is a fairly straightforward install. GM has already run some of the necessary wiring from the rear frame rail area to the engine compartment, so you will see a blue wire for the electric brake function, and an orange wire which provides 12 volt…

If you were interested in the #HM47294 Hopkins Agility brake controller you were looking at, you'd need the #HM47715 wiring adapter and the #37185 4-pole to 7-way adapter. The controller would mount to the underside of the dash in the desired…

If your truck is equipped with the factory 7-way or 4-pole trailer connector, then the brake controller install port will be present. It's usually located under the dash up and to the right of the diagnostic port. Look above and to the right of…

If your 1997 Ford F-150 came with a factory 7-Way or 4-Way then you can use the brake controller wiring adapter #3035-P for Tekonsha brake controllers, or #HM47715 for a Hopkins brake controller. I have included a link to the installation details for…

The Edge Evolutoin CS2 part #EP85350 is the correct programmer for a 2014 GMC Sierra 1500 with a 5.3 liter engine but it can only be installed on one truck at a time. So if you installed it on your truck you'd have to put your vehicle back to the…

The older tuners could only fit one vehicle at at time. The programmers like the Edge Diesel Evolution CTS3 part #EP36YR has the ability to add vehicle licenses to tune multiple vehicles with 1 product. Each vehicle must be compatible with the unit.…

To install a trailer brake controller like the Prodigy P2 #90885 or P3 #90195 along with a 7-way socket in your 1994 Ford F-150 the parts you'll need depend on how the truck was equipped from the factory. If it did not come with a factory 7-way…

On the Tekonsha Envoy and all brake controllers the four wire colors will be, white is ground, black is 12 volt power, blue goes out to the trailer connector, and red is in from the stop light circuit on the brake switch. I am including a link to a…