What Kind Of Grease To Use In The Dutton-Lainson Round Swivel Jack DL22210  

I have a solution for you, but the bracket height of the Dutton-Lainson Round Trailer Jack #DL22210 has a bracket height of 16-5/8", so it would not be short enough to be used on your trailer. I recommend usinig the Fulton F2 Swing-Up Trailer…

For your replacement swivel jack, I recommend you use a snap ring style jack like the Fulton Round, Snap-Ring Swivel Marine Jack - Bolt On - Sidewind - 10" Lift - 1,200 lbs #FTJ12000101 along with your 2 bolt assembly. I believe this will work…

The bracket height of a jack is measured from the center of the bracket to the bottom of the wheel or foot. For jack #FTJ12000101 when the jack is fully retracted as high as it will go it measures 23 inches from the bracket center to the bottom of…

The caster wheel of the Dutton-Lainson Round Swivel Jack #DL22210 that you referenced rotates freely from the rest of the jack. The inner leg is not what rotates with the wheel. I attached a review video link for this jack with more info on it for…

The profile 2000 mentioned on your 2004 23' Sea Ray Boat Trailer is actually the model of the winch. Based on the picture of the jack, we to not have a jack that is going to be an exact replacement due to the odd fasteners used to mount the jack…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

Trailer wiring generally uses 16 gauge wire, part #16-1-1. However, with a long trailer like yours you may want to go with a larger like 14 gauge #DW07550-1 or even 12 gauge #12-1-1. Each size is sold by the foot. You will need to have the lights at…