Headlight Protection Film Specs:
Features:
Apply LampGard to your headlamps, fog lamps, turn-signal lights or parking lights and never worry about scratching, cracking or pitting again. This tough, UV-resistant cover installs in seconds directly to the lamp surface for complete protection.
More Information >Videos
for Headlight Protection Film
Help Articles
for Headlight Protection Film
Expert Answers
for Headlight Protection Film
For your 2022 Ram 2500 I recommend going with the Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers item #AL88289 over the Firestone item #F2598. These have a 5,000 lbs weight capacity and the air springs have…
view full answer...I attached a picture that shows what the DeeZee Steps part #DZ16202-16255 look like when installed a Murano like your 2018 Nissan Murano. In it you can see there's plenty of clearance for mud flaps to fit in front of. So yes, this will work well…
view full answer...It sounds like you are looking for replacement mounting hardware for your Thule Mountaineer Cargo Box. For this you will just need the Replacement QM3 - Quick Mount Hardware #TH04997. This kit consists of the complete mounting hardware set, including…
view full answer...The Yakima Replacement Hitch Bolt and Clip for Yakima HoldUp Hitch Mounted Bike Carrier, part #Y8890200, is a 5/8 inch bolt. The size wrench you would use to install or remove this bolt is 15/16 inch.
view full answer...The EcoHitch Hidden Trailer Hitch Receiver part #306-X7239 is a great option for a 2016 Ford Fusion. It has the larger 2" receiver tube opening which will greatly expand the variety of hitch mounted accessories to choose from. The EcoHitch…
view full answer...If you were to install the EcoHitch #306-X7239 on your 2017 Ford Fusion then you would have to permanently remove the plastic underbody panel as you can see from the attached photo which is directly from the instructions. I have also attached a photo…
view full answer...The Blue Ox Acclaim Non-Binding Tow Bar #BX4330 is compatible with Blue Ox base plates that are between 23" and 30" apart on center. Since you're measuring 34" on center I recommend checking out the etrailer SD Non-Binding Tow Bar…
view full answer...Yes, the etrailer SD Non-Binding Tow Bar for Blue Ox Base Plates #e47ZR would have enough adjustability between the 1-1/2" shank rise/drop and the 3" of tilt to meet your 4" difference. I've attached a video below where Dave will…
view full answer...A trailer axle like part #e25GR does not have a designated speed rating. The tires that you use with this axle will be the determining factor for a speed rating. For example, the Kenda Karrier Radial Trailer Tire #AM35351DX is commonly used with the…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...The 16 inches of height that the Yakima SkyBox NX 16 Cargo Box #Y95AV that you referenced would be the height above the crossbars of your 2005 GMC Yukon Denali. I attached a review video for this cargo box for you to check out also.
view full answer...I was able to track down the installation instructions for the EcoHitch Hidden Trailer Hitch Receiver #306-X7317 referenced in your question and have attached the images from the manual below. I have also sent you a separate email with the PDF file…
view full answer...Filter Products (1)
Contact and Help
What our customers are saying:
I like the easy of navigation through the site. It only took me a couple of minutes to place my order. Thank You I will shop this sight again in the future.
Kevin
Manchester, MD