Customers compare C17057 to these similar products
Products Featured in this Video
Hi there, I'm Michael with etrailer.com. Today we're gonna take a quick look at this CURT MV Weight Distribution System. We're gonna go over some of the features and compare it to some of the weight distribution systems that we have available here at etrailer.com. So, from the start, I will let you know this is a very basic system. There are other systems out there that have a lot more advanced… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
Weight distribution works to distribute the tongue weight of a trailer up to the front axle of the tow vehicle so that it will sit more level and handle/brake better. That being said the systems do not "reduce" tongue weight or allow you to…
view full answer...Unfortunately, the Replacement Spring Bar for Curt MV Weight Distribution System #C17074 are not going to work with your Pro Series WDS. This is because the head on the two systems are different, therefore the bars wouldn't fit into the head.…
view full answer...Thank you for sending the photos they are very helpful. Based on the measurements in your photos, I think the Reese Strait-Line Weight Distribution System with Dual Cam Sway Control, #RP66075, will work for you. The snap up brackets should fit…
view full answer...You stated that you have your controller all hooked up to your 2001 Jeep Grand Cherokee. It sounds like the power wire has possibly not been connected. When properly installed, the brake controller will still turn on. For you model Jeep, we offer a…
view full answer...The Curt MV Weight Distribution System part #C17062 would not be very effective with a 14,000 lb trailer. However, you can make it effective with this weight by upgrading to the Replacement Spring Bar for Curt MV Weight Distribution System part…
view full answer...The brackets are fixed in place, but the #A04-5094BK Valterra Sewer Hose Carrier telescopes, allowing your to adjust its width from 50-94 inches. I've linked to a product demonstration video featuring the Hose Carrier.
view full answer...I went out to the warehouse and measured Replacement Cap #MJ-1500B-CP for you. The threaded part has a diameter of 2.08 inches. The overall diameter is 2.19 inches. I have included a picture showing these measurements.
view full answer...The spring locks for the Blue Ox weight distribution systems are the all the same but the attachment points are different. The only replacement option is the Replacement Spring Lock Kit for Blue Ox 2-Point Weight Distribution Hitch Head item…
view full answer...When using a weight distribution system you will have nearly the same turning ability as you would without a weight distribution system in most cases. The difference is only slight when using a system like the Equal-i-zer #EQ37120ET where other…
view full answer...The only other extension that will meet your 36" requirement is the Titan Hitch Box Extension for 2-1/2" Trailer Hitches, 41" - 48" Long #RP45018. This extension would have a maximum gross trailer weight of 7,500 lbs/750 lbs of…
view full answer...I checked with Curt and there isn't a difference between the Curt Weight Distribution systems part #C17007 and #C17057 that you referenced. Either part number will be for the same system. It's hard to say exactly what angle will cause…
view full answer...You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…
view full answer...